In the season where the rain is relatively frequent, in addition to the work UV that needs to do a good job of sterilization and dehumidification, it is also necessary to focus on the rust-proof treatment of the vehicle chassis. If it is found that the brake pump on the site of the garbage sweeper has a break in the branch pump line and a brake fluid is leaking, it can actually be made of copper or iron sheet under the branch of the branch pump. The small mat, which blocks the leaking brake fluid, can achieve a leak-stopping effect by using a tightening screw and flattening and crimping the port. However, this way of doing will cause this round to no longer achieve the braking effect, but also caused a situation of unilateral braking, so be very careful when driving a garbage sweeper. If there is a breakage in the tie rod ball joint of the garbage sweeper, if it can be ensured that the other position of the bumper will not cause the vehicle to go unsuccessfully, another screw with a length similar to the length of the ball joint can be used. Instead of breaking the ball section. After the installation curtain has its own knuckle arm assembly, it is sufficient to rivet the exposed part of the bolt. If it is a three-axle trash sweeper, if the gear oil of the differential is found to be damaged, either the rear axle or the differential on the middle bridge will be broken, it will be able to break the broken half-shaft and The drive shaft was disassembled and it was then able to continue driving. If the front differential is broken, you can disassemble the hub of the garbage sweeper and continue driving. Wait until you reach the repair station for professional repairs. If the brake master cylinder of the garbage sweeper has brake fluid missing, it can be temporarily replaced with liquor and alcohol. If there is a case of a brake cup rising, place the soaked cup in a hot water bath for between ten minutes and twenty minutes, and then deal with the place where the oil on the garbage sweeper bowl contains oil. , then it will make the cup can be restored to its original size. Fings type: laser welded fin tube
Pipe outer diameter 8.0-50.0 mm Wing outer diameter 17.0-80.0 mm wing pitch 5-13 fins / inch wing height 5.0-17 mm fin thickness 0.4 1.0 mm maximum pipe length 12.0 m.
usually,Squeeze wings Utend Power plant, chemical industry, heat recovery plant, thermal industry
The maximum operating temperature is 400 C.
Stainless Steel Welded Pipe,Stainless Steel Welded Pipes,Spiral Welding Pipe,Welded Spiral Pipe Murphy Thermal Energy Co., Ltd. , https://www.murphyfinnedtube.com
Base pipe material: steel, aluminum, copper, titanium, etc
Heat material: copper, aluminum
Wender tube length: unlimited
Product Description: 100% welded between fin and tube without filling material.The laser welding in the weld.