Submersible pump compact and lightweight, in rural areas play an important role in production and life, should pay attention to the following points in use. This article Keywords Search: More Pumps Technical Articles Motor Product Information Machining Steel is the use of CNC machining out,and the machining services including drilling, boring, cutting,meatl bending/metal bending, machining Steel Product material: carbon steel, 20#, 45#, A3, Q235,35Cr2MnMo and other series. In the high-speed machining out of the workpiece has a good finish. But machining Steel of the workpiece is easy to rust, so it will do heat treatment, surface nickel plating, chromium plating, surface black heat treatment, etc.. We have a special inspection department to carry out inspection, ensure the material aging hardness and each size to meet the requirements of the drawings, including the machining steel parts application in various industries: automotive, marine, communications, medical equipment, industrial automation equipment.Except them,we supply the sheet metal operations. Machining Steel, CNC Machining Steel, Machining Steel Parts, Metal Machining Hong Kong RYH CO., LTD , https://www.cncmachiningpart.com
First, the purchase of submersible pumps should pay attention to its model, flow and lift. If the specifications used inappropriately, will not be able to get enough water, can not play unit efficiency. In addition, we should also clarify the direction of rotation of the motor, some types of submersible pumps forward and reverse can be water, but the reversal of the small amount of water, the current is large, the reverse will damage the motor windings. To prevent submersible pump leakage in the water when working under the accident caused by electric shock, leakage protection switch should be installed.
Second, install the submersible pump , the cable should be overhead, the power cord should not be too long. Do not force the cable when the unit is launching, which may cause the power cord to break. Submersible pumps do not sink into the mud, otherwise it will lead to bad heat and burn the motor windings.
Third, try to avoid the boot at low voltage. When the voltage is too low, the motor speed will drop. If it is less than 70% of the rated speed, the centrifugal switch will be closed and the starting winding will be closed Power for a long time to heat or even burn the windings and capacitors. Do not switch the motor on and off frequently. This is because the pump will run back when it stops. If it is turned on immediately, the motor will start to load, causing the starting current to be too large to burn the winding.
Fourth, do not allow long-term overload pump operation, do not pumping large amounts of water, dehydration pump operation time should not be too long, so as not to overheat the motor and burned. During the operation of the unit, the operator must keep an eye on whether the working voltage and current are within the values ​​specified on the nameplate. If not, the motor should be stopped to find out the cause and solve the problem.
Fifth, usually more than check the motor, found under the crack, rubber seal ring damage or failure, etc., should be promptly replaced or repaired to prevent water penetration into the machine.