During the waste burning process , contaminants are set free through the help of flue gas. Therefore it becomes necessary to clean the air before discharging it into the air. And this is done through drenching the solution of lime water in the Scrubber Column. For continuous cleaning practice, a constant level is needed inside the flue gas scrubber. Our manufactured products are made up of finest quality of raw materials due to which it ensures durability in the product nature.
Scrubber Column,Tray Tower Scrubber,Exhaust Scrubber,Centrifugal Scrubber Wuxi NanQuan Pressure Vessel CO.,Ltd , https://www.nanquanvessels.com
Small pump sprinkler troubleshooting common use
Newly bought irrigation machine to re-tighten the screws in various parts before use. In the pump operation, should pay attention to bearing temperature, so that it does not exceed 75 ℃. And pay attention to the existence of noise, such as the occurrence of greater friction and percussion sound, should immediately stop inspection. When not in use, the pump should drain the water from the pump. After the pump is used for a period of time, the following fault will occur: The pump does not water the reason. Self-priming pump is not enough water storage, hand pump pressure pump body and inlet pipe water seal leakage. Suction too high, too low speed or triangular belt is too loose. The reason for the shortage of water. Filter or impeller clogged, speed is too low or too loose triangular belt. Impeller mouth serious water leakage. Bearing fever, noise and vibration larger reasons. The speed is too high, the pump shaft is bent. Incorrect bearing clearance, bearing wear or broken. In response to the above inspection, the timely adjustment or replacement. After adjusting, you can test run.