Aluminium Profile Horizontal Spraying Powder Chamber Foshan Meitu Machinery Equipment Co., Ltd , https://www.meitumachinery.com
Vortex pump failure solution
Vortex pump failure solution
If the noise of the vortex pump becomes larger, you can first check if the body is not a sundries. If yes, you should first open the shell and clearly understand the internal debris. Then check if the impeller is stuck, if it is stuck. If you live, you can contact a professional maintenance point first, and wait until the need for reassembly before you can eliminate the fault.
Secondly, check if the bearing is not damaged or not. If necessary, replace the bearing. When the air pump pressure or flow rate is reduced, it is better to cut off the power supply first. You can check whether the air intake is blocked or not. You can check the air inlet filter, but do not remove the filter, otherwise It will be sucked in, it will be easily damaged, and there will be no way to fix it.
After that, the inside of the machine can be inspected. If there is any debris, the rubber skin will hold the electromagnet, so that the electromagnet can not be restored. At this time, the housing can be opened and the internal impurities can be cleaned.
The lack of phase or direction of operation of the motor will cause pressure or flow to drop. At this time, we must check and then reconnect the power supply. If the motor is burned out, it should be replaced with the same type of motor. In the pump body temperature rise after the need for maintenance, first check the air intake to see if it is blocked, to clean the air inlet filter, be careful not to remove it, otherwise it will suck in the debris to the machinery Give damage out.